Step By Step Guide For Steroid Homebrewing:

whatsapp:+8617707569722
web: http://www.roidraw.com
email: lucy@wumeitech.com4_副本

 

In this guide I will be brewing Testosterone Enanthate. I made 10 bottles each dosed at 250mg/ml. Alright lets get started the pictures will do alot of the talking.

– An article from elitefitness

Supplies:

Scale (Get one that is sensitive enough to the gram)
Vaccum pump(Brake Bleeder)
250ml Nalgene/Millipore Filter
25grams of Testosterone Enanthate powder
18ml of Benzyl Benzoate (BB) (USP)
2ml of Benzyl Alcohol (BA) (USP)
61.25ml of Grapeseed oil
3ml syringe with 18-21 gauge needle
20ml syringe with 18-21 gauge needle
Small piece of paper
500ml beaker
100ml beaker
10 10ml vials
10 rubber stoppers
10 flip caps
Crimper

步骤1

步骤2

This is way more than 25grams but i’ll show how to measure out. Sounds simple but its kinda tricky.

步骤3

All right lets beginFirst you weigh out your powder. Now you have to do this very carefully. get your small piece of paper and place it on the scale then press tare to set it to zero so it doesnt weigh the paper. Then slowly add your powder. Now here is the tricky part the powder weighs so little that the scale needs to be reset every time you add some. All you have to do is add some then press on the scale with your finger and let the number fall back down. Once you get 25 grams your good to go.

步骤4

Then dump it into your beaker.

步骤5

Add 2ml of Benzyl Alcohol (BA) (USP)

步骤6Then add 18ml of Benzyl Benzoate BB) (USP)

步骤7Next step is sort of optional but its makes things easier. Get a pot with a bout an inch of water in it and place it on the stove and set the eye to 3.

步骤8

Put the beaker in it.

步骤9

Watch the powder dissolve and the mixture get pretty close to clear.

步骤10

步骤11步骤12

Next add you grapseed oil and let it all warm up for a bit to make filtering a little bit faster. This is a pic right after I added the oil. In put it back on the eye for a minute and mixed it.

步骤13

Then get your filter which comes with a cap for the bottom collection part.

步骤14

Next pour the oil in and attach the vacuum pump and set it between 300-400. THIS IS THE SAFETY ZONE. DONT PUSH YOUR LUCK THE BOTTOM PLASTIC CONTAINER WILL CRACK.

步骤15步骤16

Filtering (The flash on the camera makes the oil look kinda hazy)

步骤17步骤18

Done the whole filtering process takes about 30 minutes but all you have to do is pump and walk away.(Edit by WUMEITECH)

步骤19

Next you measure out 10ml in each vial

步骤20

I put the rubber stopper and flip tops on them but didnt crimp them yet.
Then you crimp.

步骤21

And now your done. 🙂  You have now made 100ml of Test E and put in 10 10ml vials. If you have questions pm me.

步骤22

Now you can start to home brew either steoid powder or steroid semi finished liquid, it is easy.

If you have question, contact with our service person, we will get back to you timely.

whatsapp:+8617707569722
web: http://www.roidraw.com
email: lucy@wumeitech.com